Windows 10 System Restore Failed Error 0x80070005: Completing a Restore That Was Blocked
System Restore runs, the PC restarts, and a message reports that it did not complete successfully. Windows 10 System Restore failed error 0x80070005 adds that the system files and settings were not changed.
The code means “access denied.” System Restore tried to replace a file and was refused, most often because another program was guarding or using it.
Antivirus software is by far the most frequent blocker. Running the restore from an http://judolbet88hoki.com/ environment where that software is not active normally allows it to finish.
What Might Be Causing It
Access is denied during a restore for these reasons:
- Antivirus or security software is protecting its own files from being changed.
- A program or service is holding files open.
- The chosen restore point is damaged.
- System protection services or permissions are not working correctly.
The error message sometimes notes that an antivirus program may be the cause.
Start With These Basic Checks
Remove the obstacles within Windows.
- Temporarily disable real-time protection in your antivirus program, or switch off its self-protection feature.
- Close all open programs.
- Type “Create a restore point,” select System Restore, tick “Show more restore points,” and try a different point.
- If that fails, start the PC in Safe Mode through Shift + Restart and run System Restore from there.
- Check that drive C has several gigabytes free.
Safe Mode loads very few programs, so the files that were locked are generally free.
Going a Step Further
Run the restore from outside Windows.
- Hold Shift and select Restart, then choose Troubleshoot > Advanced options > System Restore.
- Select your account, enter the password, and choose a restore point.
- Let the restore complete without interruption.
- If it still fails, open Command Prompt from Advanced options and run chkdsk C: /f.
- Back in Windows, run sfc /scannow, and confirm in services.msc that Volume Shadow Copy is set to Manual and can start.
A restore run from the recovery environment succeeds in most cases where the Windows-based one was blocked.
Protect Your Data First
System Restore does not delete personal files, but it removes programs and drivers installed after the restore point. Turn your antivirus back on immediately afterwards. Do not switch off the PC during a restore, since an interrupted restore can leave Windows unable to start.
The Bottom Line
Error 0x80070005 means System Restore was denied access to a file, usually by security software. Disable that protection temporarily, or run the restore from Safe Mode or the recovery menu, where it can complete freely.